W&H Bottomer AD 1500
- Brand: W&H
- Model: AD 1500
- For the production of open-mouth and valve sacks
- One valve unit
- Sack width: 350 – 650 mm
- Sack length: 460 – 1350 mm
- Bottom width (flush cut and stepped end): 70 – 180 mm. The owner produces both flush cut and stepped tubes with max bottom produced by the owner is 18 cm, but with difficulties for this max size.
- Valve length size min – max: 120 to 260 mm.
- Bottom patch unit: yes, both sides
- Bottom patch printer: 1 color, both sides
- Photocell for a pre-printed reel for a bottom patch: yes, on the left side only. Per request, the owner can put the photocell on the other side too, but in this case, the Buyer would have to purchase the controller.
- The sack transport system is half by chain and half by belt. The owner made improvements to the machine over time. For example, the initial bottom gluer was a single piece to apply glue to both sides of the sack. The owner switched to two separate sets, the same as the AD 1600.
- Visible in production until end of 2024
- Immediately available
